|
|
|
Intelligent Multifunction Charger Combo RCC-6SX+RCE-6BA |
100.72€ 201.64€ (hinta sis. alv 23%) |
|
Tuotenumero | KX850166TA | | Valmistaja | Align | | Saatavuus |  Varasto vähissä | | Toimitusaika | | |
|
RCC-6SX Intelligent multifunctional Charger/Discharger:
1. Apply to Ni-Cd, Ni-MH, Li-Ion, and Li-Poly batteries.
2. Special aluminum alloy anodic treatment outer case for good heat dissipation and great quality.
3. Use heat sink for the heat dissipation and extend the use life. 4. Automatic Ni-Cd/Ni-MH battery discharge/ charge cycle for battery activation.
5. Use RCE-6BA Li-Po Balancer to protect the batteries during charging, and extend the battery life, to improve the performance of battery and increase the power.
RCE-6BA Li-Po Balancer:
1.Separate balancing and charging ports eliminating charging amperage limit due to balancing wires’ gauge.
2.Dual mode balancer: Can be used as stand alone balancer, or concurrently with a separate charger.
3. Automatically balance 2~6 cells li-poly packs.
4. Balancing voltage resolution accurate to ±0.005V.
5. Individual cells’ balancing status displayed through LEDs.
6. Overcharging prevention circuitry with cutoff set at 4.26V/cell for additional safety, minimizing potential damages to the cells.
7. Low voltage cutoff set at 3.3V/cell to prevent over discharging of cells.
●NOTE:
Do not leave the charger is operating unattended as it may cause a fire.
●RCC-6SX Intelligent multifunctional Charger/Discharger:
●Input voltage:DC11~15V
●Charge output rate:Max 5A/125W
●Discharge rate:Max 1A/5W
●Li-Ion/Polymer:1~6cell(Auto Voltage Detection/Manual)
●Ni-MH:1~18cells
●Charge current:0.1A~5.0A(0.1A Step)
●Discharge current:0.1A~1.0A(0.1A Step)
●Discharge->Charge:1~5 cycles
●Charge->Discharge:1~5 cycles
●Safety timer:on/off, 1-900mins
●Key beep/Buzzer alarms: on/off
●12V Pb battery low voltage cut off: 11-15V(0.1V Step)
●Display:LCD 16char. x2 line(Backlight)
●Li-Ion/Polymer voltage type: Li-lon3.6V/Li-Poly3.7V
●Size:150x142x33mm
●Weight:580g
RCE-6BA Li-Po Balancer:
●Lithium polymer cell count: 2~6 cells in series configuration
●Balancing activation voltage:
Automatic:>0.03V imbalance
Manual: >0.01V imbalance
●Discharge current during balancing: 350mA
●Imbalance control voltage: +/-0.005V
●Maximum cell voltage cut off: 4.26V
●Low voltage cut off: 3.3V
●Balancing voltage resolution: +/-0.005V
●Size:83x45x19mm
●Weight:120g
●Note!
If the battery becomes hot while high current discharging or flying, please do not charge the battery immediately. Wait to cool down(about 20 mins), then inspect to recharge. If against follow the original factory using rules, possibly cause the battery to inflate or any dangerous accident happens.
|
|
|
Tuote lisätty: 12.06.2008. |
| Lisätietoja tuotteesta saat klikkaamalla tästä. |
|
|
|
|
